1 8 plastic tubing connectors
[DOC File]1) - CREL Home
https://info.5y1.org/1-8-plastic-tubing-connectors_1_bf1433.html
Four grey, 1/8” OD PVC tubes (about ¾” long) with 525 micron bore through the center (along the axis of the tubing) to align the fiber of the coupler with the fiber from the probe. (this connector will have to be made in the machine shop) The schematic of the connector is shown below in Figure 17.
[DOCX File]Introduction - Fermilab Muon Department
https://info.5y1.org/1-8-plastic-tubing-connectors_1_b677ff.html
The preliminary design uses ¼” NPT to ¼” brass compression fittings threaded into each end cap. Copper tubing, ¼” O.D., will be used to run gas line interconnections in the preliminary design. This design change anticipates the installation of TLMs in areas where plastic tubing degradation might occur due to high level beam losses.
SECTION 260533 - ELECTRICAL CONDUIT
Channel section, 12-gage (2.75 mm), 1-5/8 x 2-7/16 inches (9.53 by 39.7 mm): P5500. Studs, nuts and similar items: of sizes and types noted and compatible with channel section to which applied. Flat plate, angle, shaped and special fittings and beam clamps, of types noted and compatible with channel section to which applied.
SECTION 260533 - ELECTRICAL CONDUIT
Hanger Rods: 1/4 inch minimum, hot dip galvanized Unistrut Corp., Super Strut Corp., or equal, applied as shown. Use channel nuts, hex nuts, saddle type and flat washers and similar accessory items, each best suited to specific application: Channel section, 12-gage (2.75 mm), 1-5/8 x 2-7/16 inches (9.53 by 39.7 mm): P5500.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.