2010 chevy equinox replacement engine
[PDF File]Year/Model Interchange List -- All Makes -- Cars and Trucks
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_ce5f25.html
SRX SUV 110.5 u r,4 2010 2012 Equinox(GM says NOT) 003161 Chevrolet 2500HD, 3500HD Pickup 119,133 f r,4 2008 2012 GMC Sierra HD 002080 Avalanche Pickup/SU 130 f r,4 2007 2012 Escalade EXT 002063 Camaro 2d, Conv 112.3 u r 2010 2012 002471 Colorado Pickup 111.3,125.9 f r,4 2004 2012 Canyon 002440 Corvette 2d,Cnv 104.5 f r 2005 2012 Old XLR 002290
[PDF File]GROUP 11D ENGINE OVERHAUL
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_e5c0cd.html
11D-2 ENGINE OVERHAUL GENERAL SPECIFICATIONS M1113000202593 SERVICE SPECIFICATIONS M1113000302824 Item Specifications Engine model 4B12 Type In-line OHV, DOHC Number of cylinders 4 Combustion chamber Pentroof type Total displacement cm3 (cu in) 2,360 (144.0) Cylinder bore mm (in) 88 (3.5) Piston stroke mm (in) 97 (3.8) Compression ...
[PDF File]Balance Shaft Timing Gear Alignment on 2010-2016 GM 2.4L ...
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_bc892d.html
marks for 2010-2016 GM 2.4L VIN C, K & W engines. This information should be considered anytime the front timing chains have been removed. Important: If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise. There are two possible chain configurations for these engines. Both configurations use a unique chain
12313D –Special Coverage Adjustment – Engine Balance Chain ...
On some 2010-2011 model year Buick LaCrosse, Chevrolet Equinox, and GMC Terrain; and 2011 model year Buick Regal vehicles, equipped with a 2.4L engine (LAF), the chrome layer on the balance chain pins may wear, allowing the chain to stretch.
[PDF File]Resetting The Throttle Body Calibration (this step is ...
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_757cff.html
At this point the check engine light should change to blinking slowly indicating “Erasing ECU Memory”. 8. Release the accelerator pedal and turn the ignition switch to off. 9. Restart the engine. The check engine light should be out. Note: If the check engine light doesn't blink as described in steps 5 & 7, then the ECU isn't reset.
[PDF File]DDMWorks 2.4L Ecotec Engine Build Kit
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_8f7c6f.html
2 locating dowels on the top of the engine block towards the front and back. 4. With the head gasket installed and in place, set the cylinder head over the head studs and onto the engine block. Make sure the alignment dowels on the engine line up with the recesses in the cylinder head. The cylinder should sit all the way down onto
[PDF File]Chevrolet Equinox 2010 - CAA-Quebec
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_179d76.html
2010 CHEVROLET EQUINOX LT Chevrolet has launched the second generation of the Equinox, which rides on a highly modified version of the previous platform. The new Equinox is 1 cm shorter and 1 cm wider but otherwise similar in size to its predecessor. This compact crossover is offered with a choice of two new engines and in two- or all-wheel drive.
[PDF File]Bulletin No.: Date: Service Bulletin
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_5bc542.html
This letter is intended to make you aware that some 2010 model year Chevrolet Equinox and GMC Terrain vehicles, equipped with a 2.4L engine, may exhibit excessive engine oil consumption (less than 2,000 miles per quart of engine oil), due to piston ring wear. Check your oil level periodically.
[PDF File]Bulletin No.: Date: Service Bulletin
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_a7cf46.html
2010-2014 Chevrolet Equinox 2013 Chevrolet Malibu 2012-2013 Chevrolet Orlando 2010-2013 GMC Terrain Equipped with 2.4L Ecotec Engine (LAF, LEA or LUK) ... The Crankshaft Rear Oil Seal Replacement procedure in SI states what parts are required to complete the repair. For example, gaskets, one-time use fasteners, and ...
[PDF File]GM Variable Valve Timing VVT Camshaft Actuator System (CAS)
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_d837cd.html
engine idle. In 2004 and prior years, the GM 4.2L engine used the cam phaser on the front end of the exhaust camshaft. The camshaft is designed with a helical spline that allows the camshaft to change its position in its relationship to the camshaft drive sprocket, which changes the camshaft and crankshaft relationship, thus changing cam timing.
[PDF File]6T40-6T45 Updates and Product Concerns - .NET Framework
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_95a1e9.html
Start / idle engine . ... (RPO LUJ), Equinox, Malibu ... This condition may occur on 2010 and earlier applications. As a running change during the 2010 model year the 3 -5-Reverse/4-5-6 clutch drum and snap rings were updated to address a problem with snap ring retention. The 2nd design parts will back service if they are
[PDF File]IMS (Internal Mode Switch) Removal and Replacement
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_d0283d.html
IMS (Internal Mode Switch) Removal and Replacement The following is a quick guide to dropping the Valve Body and replacing the IMS. Start by draining the fluid and removing the oil pan. Next you’ll need to remove the VB, this can be done by disconnecting the harness and removing the 15 bolts marked in Yellow in the image to ...
[PDF File]2010 Chevrolet Equinox Owner Manual M
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_5e9c12.html
stolen, a replacement can be purchased and programmed through your dealer/retailer. When the replacement transmitter is programmed to this vehicle, all remaining transmitters must also be reprogrammed. Any lost or stolen transmitters will no longer work once the new transmitter is programmed. Battery Replacement Replace the battery if the ...
[PDF File]Timing Chain: Service and Repair
https://info.5y1.org/2010-chevy-equinox-replacement-engine_1_e40cba.html
2. Rotate the crankshaft in the engine rotational direction clockwise, until the number 1 piston is at top dead center (TDC) on the exhaust stroke. 3. Remove the camshaft cover. Refer to Camshaft Cover Replacement (See: Cylinder Head Assembly/Valve Cover/Service and Repair). 4. Remove the engine front cover.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.