230 volt outlet type

    • SPECIFICATION SECTION XXX

      The pump shall be a multi-stage type with 304 stainless steel pump housing, motor adaptor base, pump shaft, and discharge. Impellers shall be constructed of acetal. All motors must be 230 volt 1 phase with ODP motor housings. 1.25 and 2.5 gpm production systems will use a 1 horsepower motor and 3.75 gpm production systems will use a 1.5 ...

      230 volt plug types


    • [DOC File]Par-Kut International CSI Format

      https://info.5y1.org/230-volt-outlet-type_1_6fe15c.html

      Air conditioner to be a through the rear wall mounted unit with 12,000 BTU cooling and 11,200 BTU heating with dedicated 230 volt outlet. WEATHER PROOFING. A. Weather-tight for exterior use. All seams and joints pressure bonderized. All openings fully weather stripped, roof coated as specified..

      230 volt plugs and outlets


    • [DOC File]SECTION I - OAS

      https://info.5y1.org/230-volt-outlet-type_1_98e283.html

      The most common type of receptacle is the 15 or 20 a 230 volt single receptacle. Special receptacles are made for higher amperage or voltage and are designed to match the common wire sizes. General purpose duplex receptacles must be placed along all inside walls of a dwelling so no spot on the wall is more than 6 feet from a receptacle.

      20 amp 230 volt outlet


    • [DOCX File]Revised 1/14/2008 - PA - eMarketplace

      https://info.5y1.org/230-volt-outlet-type_1_12a76b.html

      Electric: Preferred - 230-volt, 3 phase service for total facility. 110v convenience outlets in receiving, shipping, packaging, office areas and on 20 building columns. One 110v outdoor outlet in weatherproof box at each shipping door.

      230 amp outlet


    • [DOC File]SECTION: 15550

      https://info.5y1.org/230-volt-outlet-type_1_93ff4e.html

      Furnish type 5052 aluminum mounting plate, inlet collar, wall mounting kit or stainless steel collector box as shown on drawings. 2.3 ELECTRICAL REQUIREMENTS. Power supply to the VFD: 230 volt or 460 volt, as shown on schedule. Power supply to the CPC-3 control: 230 volt supplied by VFD.

      single phase 230 volt wiring


Nearby & related entries: