3 1 2 exhaust pipe: free download. On-line document store on 5y1.org

[DOC File]Spec Sheet: Model PS boiler flue
https://info.5y1.org/3-1-2-exhaust-pipe_1_3c46fd.html
1:2 CONSTRUCTION. The double wall flue system shall have a 304 stainless steel inner liner and a 304 stainless steel outer jacket. The materials and construction of the modular sections and accessories shall be as specified by the terms of the product’s U.L. listing. 1.
1 1 4 exhaust tubing

[DOC File]EXHAUST SYSTEM - Henry Davis
https://info.5y1.org/3-1-2-exhaust-pipe_1_f8a829.html
Any thing larger than a 3" system and Hi-flow type mufflers is money not spent well. I myself have a 403 with 2.5" flowmaster into the stock 2.5" exhaust tail pipe. When I got rid of the stock 2" mufflers the larger piping and higher flow mufflers (220 cfm each compared with 110 cfm stock) my fuel mileage went up from 8.9 to 10.8 mpg.
2 3 4 exhaust tubing

[DOC File]Section 15575 - AMPCO
https://info.5y1.org/3-1-2-exhaust-pipe_1_6cb049.html
The exhaust system shall be designed to compensate for all flue gas induced thermal expansion. PART-2 EXECUTION. 2:1 INSTALLATION. Inner pipe joints shall be sealed by use of factory supplied overlapping V bands and sealant as specified in the manufacturer’s installation instructions.
2 inch exhaust tubing

[DOC File]Factory Pipe
https://info.5y1.org/3-1-2-exhaust-pipe_1_4d843c.html
Using the stock water-in line, attach it to the barbed fitting of the Factory Pipe exhaust manifold (item #1) and secure with a ½” SS hose clamp (item #15). Slip the manifold onto the bolts on the cylinder, align the gaskets, and secure with the four remaining 8mm x 40mm bolts (item #5). Use Loctite 242 and torque to 20 ft.-lb. where applicable.
3 inch exhaust pipe tubing

[DOCX File]Section 26 32 13, Engine Generators
https://info.5y1.org/3-1-2-exhaust-pipe_1_1331dd.html
4.Exhaust pipe size from the engine to the muffler shall be as recommended by the engine manufacturer. Pipe size from muffler to air discharge shall be two pipe sizes larger than engine exhaust pipe. 5.Connections at the engine exhaust outlet shall be made with a flexible exhaust pipe. Provide bolted type pipe flanges welded to each end of the ...
2 inch id exhaust pipe

[DOC File]Section 15XXX : CORROSIVE EXHAUST DUCTWORK
https://info.5y1.org/3-1-2-exhaust-pipe_1_3c8163.html
1. Class 1 up to -6 inch WG; scrubbed exhaust. B. Materials: Use ECTFE fluoropolymer coated stainless steel pipe in construction ductwork for the scrubbed clean room exhaust systems. PART 3 EXECUTION. 3.1 FABRICATION. A. No variation of duct configuration or sizes permitted except by written permission of the architect or design engineer.
3 stainless steel exhaust tubing

3 1 2 exhaust pipe