30 amp weatherproof disconnect
[DOC File]1 Technical Requirements - Pacific Gas and Electric Company
https://info.5y1.org/30-amp-weatherproof-disconnect_1_ad46cd.html
Disconnect Switches 110. 7.29.4. System Protection 110. 7.29.5. Control 110. 7.29.6. Power Metering 110. ... Equipment identification and components may use engraved plastic or weatherproof nameplates, where appropriate. ... Pre-filter efficiency shall be 30% and final filter efficiency shall be 80% based on ASHRAE 52.1-1992 or approved ...
[DOC File]NEW MEXICO DEPARTMENT OF TRANSPORTATION
https://info.5y1.org/30-amp-weatherproof-disconnect_1_3ce597.html
Main Breaker Assembly for Power In to accommodate one (1) 30 amp leg and one (1) 15 amp leg. Ethernet controlled remote service relay system- This system must be compatible with existing NMDOT control software. Contact NMDOT ITS Bureau regarding existing software details. At a minimum the sign controller will contain the following options:
[DOC File]SECTION 28 31 11 - DIGITAL, ADDRESSABLE FIRE ALARM …
https://info.5y1.org/30-amp-weatherproof-disconnect_1_4f1be4.html
Three Phase 100 Amp Circuit breaker panel. All interior equipment shall be pre-wired to the distribution panel. The panel shall be furnished with (3) spare 30 Amp 2 phase spare breakers for exterior loads. Piping for pump, including suction main, control valve, relief …
[DOCX File]END OF SECTION - University of Houston
https://info.5y1.org/30-amp-weatherproof-disconnect_1_f956b7.html
30 amp, 125/250 volt, grounded, 4wire,Hubbell #HBL9430A with #S701 3-pole NEMA #1430Rstainless steel wall plate. 30 amp, 125/250 volt, grounded, locking,Hubbell #HBL2710 with #7420 cast4 wire, 3-pole NEMA #L14-30R (windowaluminum weatherproof wall plate.washing receptacle)
[DOC File]EarthCam, Inc
https://info.5y1.org/30-amp-weatherproof-disconnect_1_0829af.html
Weatherproof Rating: NEMA 6P and IP67 standards. Operational Temperature: - 40°F to 122°F (- 40°C to 50°C) Dimensions: Camera Enclosure: 10.5”Diameter x 11.63”H (267mmx295mm) Weight: 16 lbs (7.26 kg). Solar Powered Trailer Platform: Operational Temperature Range –4ºF to 158ºF (-20ºC to 70ºC)
[DOC File]2400VFX Aerating Fountain Specifications_______________
https://info.5y1.org/30-amp-weatherproof-disconnect_1_b2319a.html
An underwater approved, potted, O-ring sealed quick disconnect shall be factory installed on 12, 10, 8, & 6 AWG power cables approximately 30” from the motor housing. A Series 300 stainless steel clamp on strain relief with stainless steel chain and connector shall be installed on the power source side of the quick disconnect and attached to ...
[DOC File]SECTION: GRINDER PUMP UNITS - Environment One
https://info.5y1.org/30-amp-weatherproof-disconnect_1_cbe348.html
SECTION: GRINDER PUMP STATIONS. 1.0 General. 1.01 GENERAL DESCRIPTION: The . MANUFACTURER. shall furnish complete factory-built and tested grinder pump unit(s), each consisting of a grinder pump core suitably mounted on an integral stand of stainless steel, electrical quick disconnect (NEMA 6P), pump removal harness, discharge assembly/shut-off valve, anti-siphon valve/check valve …
[DOC File]Functional specification for Form 6 pole-mount recloser ...
https://info.5y1.org/30-amp-weatherproof-disconnect_1_9c7093.html
8 Amp-Hour — 15 hour maximum (20°C) 13 Amp-Hour — 25 hour maximum (20°C) In the event that the AC power has not returned within the times listed above, the control shall disconnect the battery from the circuit. The control shall continuously monitor the battery voltage.
[DOC File]SECTION I - OAS
https://info.5y1.org/30-amp-weatherproof-disconnect_1_98e283.html
Laundry rooms (where an electric washing machine is being used) need one 15 amp single outlet for the washing machine and one 20 amp duplex outlet for the iron, etc. An electric dryer will need a 30 amp 240 volt outlet. Garages need only one 20 amp duplex outlet. Receptacles and switches must always be mounted in a suitable metal or plastic box.
[DOC File]2400VFX Aerating Fountain Specifications_______________
https://info.5y1.org/30-amp-weatherproof-disconnect_1_ebdb87.html
The power cable shall be available in 50’ 16 AWG, 100’ 14 AWG, 150’ 12 AWG, and 200’ 12 AWG cord lengths and gauges. An underwater approved, potted, O-ring sealed quick disconnect shall be factory installed on 12 AWG power cables approximately 30” from the motor housing.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.