60 amp fused disconnect box: free download. On-line document store on 5y1.org

[DOCX File]ELECTRICAL FOR STEAM UTILITY DISTRIBUTION
https://info.5y1.org/60-amp-fused-disconnect-box_1_5b1aca.html
Provide combination, full voltage, nonreversing magnetic starters and fusible disconnect switches in a common enclosure. Fractional sizes and ratings in accordance with IEC recommendations are not acceptable. Provide fused 3-pole load break disconnect switches with time delay, dual element fuses, external operating handle, and lock-off facility.
60 amp disconnect switch

[DOC File]Boiler System Requirements – Please complete this document ...
https://info.5y1.org/60-amp-fused-disconnect-box_1_4e7e05.html
Constituent Value Fuel Natural Gas Supply Voltage 120/1/60 Operating Principle ON/OFF BTU Rating 398 MBH Minimum Gas Inlet Pressure 6” w.c. Maximum Gas Inlet Pressure 9” w.c. Manifold Pressure 4” w.c. Oxygen (O2) 5% to 6% Carbon Dioxide (CO2) 0% to 10% Carbon Monoxide (CO) Less than 400 ppm Nitrogen Oxides (NOX) Less than 25 ppm ...
60 amp fused disconnect switch

[DOCX File]Lighting and Signals Section Method Notes
https://info.5y1.org/60-amp-fused-disconnect-box_1_bf98d3.html
The Contractor will install a NEMA 3R rainproof, 60 amp rated, non-fused safety switch (with lock) adjacent to the traffic signal cabinet. The secondary disconnect will be mounted on a galvanized steel post in accordance with standard plate 635.41.
60 amp fusible disconnect switch

[DOC File]48A3, 48A5, 48A7, 48A9, 50A3, 50A5, 50A7, 50A9 Guide ...
https://info.5y1.org/60-amp-fused-disconnect-box_1_705893.html
When applied with a unit-mounted disconnect, the outlet shall be wired to the load side of the disconnect so the outlet will shut off with the disconnect. Non-Fused Disconnect Switch: Shall be factory installed, internally mounted, and UL approved. Non-fused switch shall provide unit power shutoff.
60 amp non fused disconnect

[DOC File]PSG Section 26 28 16.13 - Eaton
https://info.5y1.org/60-amp-fused-disconnect-box_1_b52be5.html
The Contractor shall furnish and install the low-voltage fused and non-fused switches as specified herein and as shown on the contract drawings. Related Sections. References. The switches and all components shall be designed, manufactured and tested in accordance with the latest applicable standards: NEMA KS-1. UL 98. Submittals – for Review ...
60a fusible disconnect

[DOC File]PSG Section 16441A - Eaton
https://info.5y1.org/60-amp-fused-disconnect-box_1_b92f43.html
Receptacle shall be located in an end-use box on the side of the enclosure. Solar Disconnect switches. Provide 30- to 600-ampere switches as shown on the drawings for solar installations with the following ratings and characteristics: Switches shall be UL listed for 600vDC, and shall be wired according to the listing instructions.
60 amp ac disconnect

60 amp fused disconnect box