60 amp non fused disconnect
[DOC File]PRODUCT -- HYDRAULIC ELEVATORS – In-Ground (Model …
https://info.5y1.org/60-amp-non-fused-disconnect_1_e30898.html
Additional, fused 120 VAC, 15 Amp, and / or any in-car GFCI duplex receptacles (one disconnect per elevating device), oil cooler and oil heater. Hoistway ventilation and temperature control required to maintain temperature between 10° C to 32° C. Maximum allowed humidity is 95% non-condensing. Ventilation to be according to local Codes.
[DOC File]BASIC NEC CODE RULES AND DESIGN PRACTICE
https://info.5y1.org/60-amp-non-fused-disconnect_1_7ba407.html
70 25-42 60. 43 and above 50 *If circuit is loaded up to 80% ampacity, then 6 phase wires can be put in one conduit. ... CIRCUIT BREAKER SIZE Amp* 75°C THW WIRE SIZE MAXIMUM Amps. Non-motor load any load any load. ... The service entrance, service drop, and fused disconnect on the meter pole must be changed to a higher ampacity when additional ...
[DOC File]PSG Section 16441A - Eaton
https://info.5y1.org/60-amp-non-fused-disconnect_1_b92f43.html
The Contractor shall furnish and install the low-voltage fused and non-fused switches as specified herein and as shown on the contract drawings. ... 30 A to 60 A NEMA 1 enclosures shall have tangential knockouts on the top, bottom and sides of the enclosure. ... or [Cam-Lok] type. 600 amp and 800 amp switches shall employ parallel receptacles ...
[DOC File]30RB Guide Specifications, 60 to 300 tons (210 to 1055 kW ...
https://info.5y1.org/60-amp-non-fused-disconnect_1_b294d6.html
Unit-Mounted Non-Fused Disconnect: Unit shall be supplied with factory-installed, non-fused electrical disconnect for main power supply. This option is not available on 30RB060-120 with dual point power. This option is included with the high SCCR option. Optional Condenser Coil Materials: E-coated microchannel coils:
[DOCX File]Lighting and Signals Section Method Notes
https://info.5y1.org/60-amp-non-fused-disconnect_1_bf98d3.html
The Contractor will install a NEMA 3R rainproof, 60 amp rated, non-fused safety switch (with lock) adjacent to the traffic signal cabinet. The secondary disconnect will be mounted on a galvanized steel post in accordance with standard plate 635.41.
[DOC File]Mestek, Inc. SalesAssistant
https://info.5y1.org/60-amp-non-fused-disconnect_1_77ffd1.html
Optional Power disconnect, electric heat fused disconnect (30 amp), non-fused disconnect switch (20 amp) or toggle operated fused quick disconnect switch. Optional Speed switch – unit mounted 3-speed switch – horizontal models, omit 3-speed switch.
[DOC File]48A2, 48A4, 48A6, 48A8, 50A2, 50A4, 50A6, 50A8 Guide ...
https://info.5y1.org/60-amp-non-fused-disconnect_1_5ab610.html
When applied with a unit-mounted disconnect, the outlet shall be wired to the load side of the disconnect so the outlet will shut off with the disconnect. Non-Fused Disconnect Switch: Shall be factory installed, internally mounted, and UL approved. Non-fused switch shall provide unit power shutoff.
[DOC File]1 - Cooper Industries
https://info.5y1.org/60-amp-non-fused-disconnect_1_d4f67f.html
A 1200 A Primary Air Load-break Switch is available as an option. Note: The transformer must be specified with the High Voltage Flange in order to provide the primary air disconnect switch. [ ] The transformer primary shall be non-fused. It shall include a copper bus transition to the transformer. Note: Required when full load current exceeds 600A.
[DOCX File]ELECTRICAL FOR STEAM UTILITY DISTRIBUTION
https://info.5y1.org/60-amp-non-fused-disconnect_1_5b1aca.html
Provide combination, full voltage, nonreversing magnetic starters and fusible disconnect switches in a common enclosure. Fractional sizes and ratings in accordance with IEC recommendations are not acceptable. Provide fused 3-pole load break disconnect switches with time delay, dual element fuses, external operating handle, and lock-off facility.
[DOC File]PSG Section 26 28 16.13 - Eaton
https://info.5y1.org/60-amp-non-fused-disconnect_1_b52be5.html
The Contractor shall furnish and install the low-voltage fused and non-fused switches as specified herein and as shown on the contract drawings. Related Sections. References. The switches and all components shall be designed, manufactured and tested in accordance with the latest applicable standards: NEMA KS-1. UL 98. Submittals – for Review ...
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.