Air and fire compatibility
[DOCX File]SECTION 078446 - FIRE-RESISTIVE JOINT SYSTEMS
https://info.5y1.org/air-and-fire-compatibility_1_f3479f.html
Ventilate fire-resistive joint systems per manufacturer's written instructions by natural means or, if this is inadequate, forced-air circulation. COORDINATION. Coordinate construction of joints to ensure that fire-resistive joint systems are installed according to specified requirements.
[DOCX File]The Air Barrier Association of America (ABAA) | Home
https://info.5y1.org/air-and-fire-compatibility_1_9776bd.html
Agenda shall include, at a minimum, construction and testing of mock-up, sequence of construction, coordination with substrate preparation, air barrier materials approved for use, compatibility of materials, coordination with installation of adjacent and covering materials, and details of construction and chemical/fire safety plans.
[DOCX File]SECTION 28 46 00 - FIRE DETECTION AND ALARM
https://info.5y1.org/air-and-fire-compatibility_1_6cd33c.html
90A-2009Installation of Air Conditioning and Ventilating Systems. 101-2012Life Safety Code. ... D.Shall be UL listed for fire alarm use and compatibility with the panel to which they are connected. E.Shall be mounted in weatherproof housings if mounted exterior to a building.
[DOCX File]SECTION 072726.03 – FLUID-APPLIED MEMBRANE AIR …
https://info.5y1.org/air-and-fire-compatibility_1_6ef632.html
To provide further assurance of protection, Tremco has gone beyond traditional manufacturer testing and performed adhesion and compatibility testing on related components that connect to ExoAir 230, including a complete line of air barrier systems provided by Tremco under the ExoAir brand, the us of Proglaze® ETA (Engineered Transition ...
[DOC File]SOP 4.6: Aerosol Can Puncturing Procedures
https://info.5y1.org/air-and-fire-compatibility_1_79311b.html
Cans are discharged from unit. Air-dry empty cans in a well-ventilated area prior to recycling. Full 55-gallon drums may be disposed of using the state contracted HW disposal company. 7.7 Managing empty and drained aerosol cans. Empty, steel aerosol cans are accepted by the steel industry; verify with local recycling programs.
[DOCX File]Architectural Specification (Section 072726 - Factory ...
https://info.5y1.org/air-and-fire-compatibility_1_b51d7b.html
Preparation and treatment requirements for transition substrates, and compatibility information. ... Retain "Fire-Resistance-Rated Assemblies" Paragraph below where factory fluid-applied air and water barrier panel is part of fire-resistance-rated assemblies. Indicate design designations of specific assemblies on Drawings.
[DOCX File]Roofing, Insulation, and Composite Materials | Owens Corning
https://info.5y1.org/air-and-fire-compatibility_1_d492c7.html
(fire resistance), ASTM E2357 (air leakage), and ASTM E331 (water penetration) requirements. Verification from the proposed manufacturers of independent third party testing that the proposed system substitution meets the ASTM C794 (adhesion) and AAMA 713 (compatibility) requirements.
[DOC File]SECTION 283100 - FIRE DETECTION AND ALARM
https://info.5y1.org/air-and-fire-compatibility_1_7da5da.html
SECTION 283100 - FIRE DETECTION AND ALARM. ... Signal HVAC system to shut down new air handling units. Interrupt power to magnetic locks at emergency exits. ... Strobes shall be supplied by the panel manufacturer to ensure system compatibility and proper UL compatibility listings. In/out screw terminals shall be provided for wiring.
[DOC File]Secction 072702 - Air Barrier
https://info.5y1.org/air-and-fire-compatibility_1_9f7780.html
Agenda shall include, at a minimum, construction and testing of mock-up, sequence of construction, coordination with substrate preparation, air barrier materials approved for use, compatibility of materials, coordination with installation of adjacent and covering materials, and details of construction and chemical/fire safety plans.
[DOC File]SFP-5UD/10UD Five/Ten Zone Fire Alarm Control Panels (DOC)
https://info.5y1.org/air-and-fire-compatibility_1_64c371.html
C. The fire alarm system shall be manufactured by an ISO 9001 certified company and meet the requirements of BS EN9001: ANSI/ASQC Q9001-1994. D. The Fire Alarm Control Panel (FACP) and peripheral devices shall be manufactured 100% by a single U.S. manufacturer (or division thereof). E.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.