Air compressor vibration foot pads

    • [DOC File]SP R.20

      https://info.5y1.org/air-compressor-vibration-foot-pads_1_632634.html

      Removable protective covers shall be provided. Pads or targets shall be located close to the machinery support points. . For baseplates longer than 6 m. (20 ft.), additional pads shall be located at intermediate points. [616][617] Note To Task Force Chairman: The above provisions may be required only for special purpose equipment.

      air compressor rubber foot pads


    • [DOCX File]END OF SECTION - University of Houston

      https://info.5y1.org/air-compressor-vibration-foot-pads_1_eae30e.html

      Work Included: Provide vibration isolation supports for all equipment, piping and ductwork as may be required to prevent transmission of vibration and noise to the building structure. Expected noise levels in various parts of the building shall conform to noise criteria recommendations as set forth in the ASHRAE 1987 HVAC Systems and ...

      air compressor anti vibration feet


    • [DOCX File]Home | Infrastructure Planning and Facilities

      https://info.5y1.org/air-compressor-vibration-foot-pads_1_4cdb04.html

      Mount compressor and tank unit on vibration isolators as specified in Division 23 Section "Vibration Controls for HVAC Piping and Equipment." Isolate air supply with wire-braid-reinforced rubber hose. Secure and anchor according to manufacturer's written instructions and seismic-control requirements.

      rubber feet for air compressor


    • [DOC File]PART 1 - Broward County Public Schools

      https://info.5y1.org/air-compressor-vibration-foot-pads_1_ea2b9a.html

      The pads shall extend a maximum of 4 inches beyond the foot[print of the supported equipment in all directions and have 1/2 inch chamfered edges. When the AHUs are provided with a minimum 6 inch factory installed base rails, the use of the 6 inch concrete pads shall not be required.

      air compressor isolation mounting pads


    • [DOC File]Data Aire Series DX Units Guide Specifcations

      https://info.5y1.org/air-compressor-vibration-foot-pads_1_abf0ae.html

      The supply air fans shall be single width, single inlet plenum fan with backward inclined blades. Fan wheel shall be directly connected to its motor for greater efficiency. Fan/motor assembly shall be statically and dynamically balanced for quiet, vibration-free operation. Fan …

      air compressor feet pads


Nearby & related entries: