Amtrol well tank sizing
[DOC File]END OF SECTION - University of Houston
https://info.5y1.org/amtrol-well-tank-sizing_1_2bb7a3.html
The outside of each tank shall be factory-painted with a primer and two coats of enamel after fabrication. Each tank shall bear an appropriate ASME label for the system working pressures and temperatures. Manufacturers: Tanks manufactured by Amtrol, Armstrong, Taco, or Woods Industrial and meeting the above specifications will be acceptable.
[DOC File]TICEL BIO PARK II
https://info.5y1.org/amtrol-well-tank-sizing_1_395f42.html
The cable sizing shall be done based on the manufacturer's data. Each individual motor feeder shall have a continuous capacity of at least 125% of the motor full load current. The minimum capacity of a cable supplying a group of motors should be at least equal to the sum of the full load current ratings of all the motors plus 25% of the full ...
[DOCX File]This section has been written to cover most (but not all ...
https://info.5y1.org/amtrol-well-tank-sizing_1_c5d9d3.html
Tank: 316L stainless steel or phase-balanced austenitic and ferritic duplex steel with minimum 21% chromium mill certified per ASTM A 923 Method A rated for 150 psig complete with stainless steel pipe fittings, submerged combustion chamber, 90/10 cupronickel or 316L stainless steel heat exchanger, insulation, plastic jacket, brass drain valve and temperature and pressure relief valve.
[DOC File]Section 15010 Mechanical Provisions
https://info.5y1.org/amtrol-well-tank-sizing_1_817fc4.html
A. Carbon steel tank with heavy-duty butyl diaphragm, ASME rated for 240 deg F at 125 psig, gallon capacity as required. B Mfg: Bell and Gossett, Amtrol, Taco, Teel or equal. (7) Heat Trace: Raychem Wintergard Wet with metal braid and waterproof outer jacket, 120V, 6 watts per foot.
SECTION 232116 - HYDRONIC PIPING SPECIALTIES
Tank: Welded steel, rated for 125-psig working pressure and 375 deg F maximum operating temperature. Factory test after taps are fabricated and supports installed and are labeled according to ASME Boiler and Pressure Vessel Code: Section VIII, Division 1.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.