Amtrol well tanks with bladder
[DOC File]Section 15010 Mechanical Provisions
https://info.5y1.org/amtrol-well-tanks-with-bladder_1_817fc4.html
(6) Tank, Bladder, Type: A. Tank with bladder with the acceptance volume (to be determined), ASME constructed. B. Connections shall include system connection, charging valve, and drain connections. C. Mrf: Amtrol or equal. (7) Air Separator:
[DOC File]END OF SECTION - University of Houston
https://info.5y1.org/amtrol-well-tanks-with-bladder_1_8e4c7d.html
Hydropneumatic Tanks: Amtrol, Inc. Taco. Woods. ... as well as copper tubing with shutoff cocks for gauges and pressure switches, will be furnished assembled. The only field connections required will be system suction, discharge, and power connection at the control panel. ... where shown on the Drawings, a vertical bladder type hydropneumatic ...
[DOCX File]This section has been written to cover most (but not all ...
https://info.5y1.org/amtrol-well-tanks-with-bladder_1_c5d9d3.html
Provide structural steel leg supports, 4” x 6” top and side hand holes for tanks 30” and smaller and 12”x16” top hand hole and 6”x 8” side hand hole for larger tanks. Blast carbon steel tank exterior to SSPC-SP10 or NACE No. 2, near white metal with 2 mil minimum anchor pattern profile and apply one coat epoxy (Tnemec Series N69F ...
[DOC File]END OF SECTION - University of Houston
https://info.5y1.org/amtrol-well-tanks-with-bladder_1_2bb7a3.html
Meter: Provide a differential pressure meter calibrated for flow in gpm for initial balance as well as for the Engineer to verify balance. This meter shall be turned over to the Owner during the Owner training period. COMPRESSION/EXPANSION TANKS: General: Provide a diaphragm-type pre-pressurized expansion tank with replaceable bladder.
[DOCX File]23 05 15 - DOA Home
https://info.5y1.org/amtrol-well-tanks-with-bladder_1_8e2d96.html
SECTION 23 05 15. PIPING SPECIALTIES . BASED ON DFD MASTER SPECIFICATION DATED 12/07/2020. This section has been written to cover most (but not all) situations that you will encounter. Depending on the requirements of your specific project, you may have to add material, delete material, delete items, or modify what is currently written.
SECTION 232116 - HYDRONIC PIPING SPECIALTIES
Install expansion tanks on the floor. Vent and purge air from hydronic system, and ensure that tank is properly charged with air to suit system Project requirements. Retain one of first two paragraphs below according to air separator specified in Part 2.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.