Asphalt roofing installation
[DOC File]HOT APPLIED RUBBERIZED ASPHALT GUIDE SPECIFICATION
https://info.5y1.org/asphalt-roofing-installation_1_c7012f.html
Hot Roofing Asphalt: Roofing asphalt heated to its equiviscous temperature (EVT), the temperature at which its viscosity is 125 centipoise for mop-applied roofing asphalt and 75 centipoise for mechanical spreader-applied roofing asphalt, within a range of plus or minus 25 deg F (14 deg C), measured at the mop cart or mechanical spreader ...
[DOC File]Division 07 - Built-up Bituminous Roofing (Asphalt)
https://info.5y1.org/asphalt-roofing-installation_1_ff39ac.html
Install 2 glass-fiber felt plies lapping each sheet 19 inches (483 mm) over preceding sheet. Embed each sheet in a solid mopping of hot roofing asphalt. Glaze-coat completed surface with hot roofing asphalt. Apply hot roofing asphalt at a rate of 20 lb/100 sq. ft. (1 kg/sq. m), plus or minus 25 percent.
How to Install Asphalt Shingles - Roof Shingles Installation Guide - …
SECTION 07 51 13.11HOT-APPIED BUILT-UP ASPHALT ROOFING. SPEC WRITER NOTE: 1. Delete text between // // not applicable to project. Edit remaining text to suit project. 2. This roofing system is not to be used for any patientoccupied buildings. 3. Slopes: Do …
[DOCX File]SECTION 075113 - BUILT-UP ASPHALT ROOFING
https://info.5y1.org/asphalt-roofing-installation_1_d060b7.html
.2 CGSB-37-GP-50M89: Hot Applied Rubberized Asphalt for Roofing and Waterproofing..3 CGSB-37-GP-51M: Application of Hot Applied Rubberized Asphalt for Roofing and Waterproofing..4 CGSB-37-GP-56M: Membrane, Bituminous, Prefabricated and Reinforced for Roofing. ... No installation work shall be performed during rainy or inclement weather and on ...
[DOCX File]SECTION 07 51 13.13 - COLD-APPLIED BUILT-UP ASPHALT …
https://info.5y1.org/asphalt-roofing-installation_1_8d532d.html
Where roof slope exceeds 12:12, seal asphalt shingles with asphalt roofing cement spots after fastening with additional roofing nails located according to manufacturer’s written instructions. Retain subparagraph below for low-sloped roofs. Where roof slope is less than 4:12, seal asphalt shingles with asphalt roofing cement spots.
[DOCX File]SECTION 07 31 13 - ASPHALT SHINGLES
https://info.5y1.org/asphalt-roofing-installation_1_93104d.html
Coordinate roofing membrane installation with flashing work and roof insulation work so insulation and flashing are installed concurrently to permit continuous roofing operations. Complete installation of flashing, insulation, and roofing in same day except for the area where temporary protection is required when work is stopped for inclement ...
[DOC File]SECTION 075113 - BUILT-UP ASPHALT ROOFING
https://info.5y1.org/asphalt-roofing-installation_1_fa5b86.html
Prior to roofing system installation, roofing sub-contractor shall provide a copy of the Guarantee Application Confirmation document issued by Johns Manville Roofing Systems indicating that the project has been reviewed for eligibility to receive the specified guarantee and registered.
[DOC File]SECTION 075113 - BUILT-UP ASPHALT ROOFING
https://info.5y1.org/asphalt-roofing-installation_1_e421c1.html
Asphalt Heating: Heat roofing asphalt to temperature recommended by roofing manufacturer to flux modified membrane. Do not exceed roofing asphalt manufacturer's recommended temperature limits during roofing asphalt heating. Discard roofing asphalt maintained at a temperature exceeding finished blowing temperature for more than 4 hours.
[DOC File]SECTION 07311 - ASPHALT SHINGLES
https://info.5y1.org/asphalt-roofing-installation_1_200c85.html
DIVISION 7 - THERMAL & MOISTURE PROTECTION. Section 07 51 13 - Built-Up Bituminous Roofing (Asphalt) GENERAL. WORK INCLUDES. Base Bid: (*General) (*General/Roofing) Contractor provide 4 ply glass fiber felt, asphalt, gravel surface built-up roofing and flashing systems as shown and specified.
[DOCX File]SECTION 07 51 13.11 - HOT-APPLIED BUILT-UP ASPHALT …
https://info.5y1.org/asphalt-roofing-installation_1_b644d7.html
Verify roof substrates are sound, within manufacturer's tolerances, and free from defects which would interfere with roofing installation. Verify roof accessories, vent pipes and other projections through roof are in place and roof flashing is installed, or ready for installation, before installing shingles.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Hot searches
- government helps first time buyers
- distance time graph gizmo answer key
- education technology
- what helps viagra work better
- why should a poll be scientific rather than informal
- how education helps society
- how technology helps kids
- grade 11 past papers history
- organizations that helps schools
- react axios get example