Asphalt square feet per ton: free download. On-line document store on 5y1.org

[DOC File]SWC 501, Asphalt, Hot Mix
https://info.5y1.org/asphalt-square-feet-per-ton_1_353ae4.html
(1) Hot mix, asphalt, D grading, $20.00 per ton (2) Haul costs as per TDOT's current haul cost chart for 50 miles is $0.14 per mile. **user agencies shall be responsible for obtaining and maintaining the TDOT current haul cost chart. Computed as follows: (1) 30 tons of asphalt products, hot mix @ $20.00/ton …
cost of asphalt per ton

[DOCX File]REVIEW OF NEW SPECIFICATION OR SPECIFICATION CHANGE
https://info.5y1.org/asphalt-square-feet-per-ton_1_f586d4.html
The quantity of asphalt emulsion per square yard may vary from the rate shown in the Contract, as directed. A strip of building paper, at least 3 feet in width and with a length equal to that of the spray bar of the distributor plus 1 foot shall be used at the beginning of each spread.
weight of asphalt per ton

SUPERPAVE ASPHALT CONCRETE
Sample the asphalt mixture at the plant in accordance with FM 1-T 168. The percent asphalt binder content of the mixture will be determined in accordance with FM 5-563 (ignition oven). The gradation of the extracted mixture will be determined in accordance with FM 1-T 030. All test results will be shown to the nearest 0.01.
how much asphalt per ton

[DOC File]SECTION 903 - HOT MIX ASPHALT (FORMERLY BITUMINOUS …
https://info.5y1.org/asphalt-square-feet-per-ton_1_bc2f30.html
a lot should be a maximum of 10,000 square yards in area and will apply to all projects whether the project payment quantities for hot mix asphalt surface course, hot mix asphalt intermediate course or hot mix asphalt base course are measured on a square yard or ton basis. ... asphalt 0.55. table 920-8 reduction per lot due to nonconformance of ...
cubic foot to tons asphalt

SECTION 310 .fl.us
Liters of Asphalt Cement per Square Meter. Liters of. Emulsified Asphalt per Square Meter. 1-A. 56. 0.014-0.016. 0.015-0.018. 1.4 - 2.0. 1.6 - 2.4. 1-B. 6. ... Cubic Feet per Square Yard. Gallons of AC or RC per Square Yard. Gallons of Emulsified Asphalt per Square Yard. 6. ... Provide rollers that are 3 to 5 ton [2.7 to 4.5 metric ton] steel ...
tons of asphalt per truck

[DOC File]01270, Measurement and Payment
https://info.5y1.org/asphalt-square-feet-per-ton_1_472413.html
Payment will be made at the contract unit price per ton. ASPHALT CONCRETE SURFACE COURSE (3 INCH THICKNESS) – S.Y. ASPHALT CONCRETE SURFACE COURSE (4 INCH THICKNESS) – S.Y. Pay quantity will be the number of square yards of asphalt concrete accepted in place. Payment will be made at the contract unit price per square yard.
tons of asphalt per sf

32 12 43 Porous Asphalt
Three (3) surface infiltration tests per ASTM C1701 shall be conducted per 10,000 square feet of porous asphalt, in place and one (1) additional test per 5,000 square feet of porous asphalt, or fraction thereof, in place. Document and record the results of each field infiltration test with a designated test number.
asphalt calculator cost per ton

[DOC File]PART 1
https://info.5y1.org/asphalt-square-feet-per-ton_1_679099.html
Place asphaltic concrete at an average rate of 20 square yards per ton. Spread mixture with mechanical spreaders. Seal roll mixture using tandem steel rollers weighing between 5 and 12 tons and following as close behind spreader as possible.
asphalt tons per square yard

[DOCX File]SECTION 409—SUPERPAVE MIXTURE DESIGN, STANDARD …
https://info.5y1.org/asphalt-square-feet-per-ton_1_984694.html
Scratch courses or leveling courses less than 1-inch in depth or equal to or less than 110 pounds per square yard. Areas of paving or patching less than 4 feet in width or narrow enough to cause bridging of the area by approved compaction equipment.
cost of asphalt per ton

[DOC File]STI Memo Template - California Air Resources Board
https://info.5y1.org/asphalt-square-feet-per-ton_1_12f4d9.html
The EIIP (2000) estimates that 15-60 pounds (typically 20 lb) of asphalt are consumed per 100 square feet of roofing materials used. This factor in combination with estimates of annual usage of roofing materials can be used to generate a statewide estimate of the amount of asphalt used to install roofing.
weight of asphalt per ton

Asphalt square feet per ton