Doi 10 1515 ijcre 2021 0185

    • Dr. Diwakar Z. Shende_publications – Department of ...

      Kumar, A., Shende, D.Z., Wasewar, K.L., Experimental and Design Investigation for Reactive Extraction of Levulinic Acid in Non-toxic Solvent, International Journal of ...


    • Optimization and experimental design by response surface ...

      The effect of different factors like initial acid concentration (5–10%, w/w), initial TBP concentration in ionic liquids (0–3 mol L⁻¹), and aqueous/organic phase ratio (0.5–1.5) on the ...


    • [XLSX File]kgau.ru

      https://info.5y1.org/doi-10-1515-ijcre-2021-0185_1_8cc2bf.html

      13273J ACM SIGCOMM Computer Communication Review EH001 ASSOC COMPUTING MACHINERY http://www.sigcomm.org/learn/computer-communication-review 0146-4833


    • Computational Simulation of Mixing Performance in the ...

      Abstract Computational fluid dynamics (CFD) was used to investigate the turbulent mixing performance in a vertical CJT in the range of Re=3,668−18,342. Energy source of hot water was centrally placed just below the top of the tank and temperature instead of concentration measurements were used to quantify mixing performance. The 95 % criterion for temperature equilibrium was employed to ...


    • The technical and economic comparison of ethylene ...

      Objective The International Journal of Chemical Reactor Engineering covers the broad fields of theoretical and applied reactor engineering. The IJCRE covers topics drawn from the substantial areas of overlap between catalysis, reaction and reactor engineering. The journal is presently edited by Hugo de Lasa and Charles Xu, counting with an impressive list of Editorial Board leading specialists ...



    • Pyrolysis-catalytic upgrading of bio-oil and pyrolysis ...

      Fast-rising population and economic growth are inducing a rapid increase in the energy demand. To date, fossil fuels constitute the primary energy source, but their combustion emits greenhouse gases responsible of global warming. Therefore, developing environment-friendly energy sources is critical. For instance, pyrolysis converts biomass into valuable compounds such as syngas, biochar, and ...


    • CFD Modeling of Algae Flash Pyrolysis in the Batch ...

      Azizi et al. [10] used a two fluid model based on kinetic theory to study the heat transfer of gas solid flows in a vertical pneumatic conveyor and showed that heat transfer coefficient of gas ...


    • Effect of reaction temperature on the conversion of algal ...

      HTL, in general, performed in the temperature and pressure between 280–370 °C and 10–25 MPa, respectively, produces bio-oil and also solid residue (s), gases, and aqueous phase products . The typical HTL processing of algal biomass into various products is illustrated in Fig. 1 .


    • [XLSX File]urfu.ru

      https://info.5y1.org/doi-10-1515-ijcre-2021-0185_1_495375.html

      Edition D2783J 2D Materials NW493 IOP PUBLISHING LTD WoS 3 http://iopscience.iop.org/2053-1583/ 2053-1583 ENGLAND EU English Materials Science, Multidisciplinary


    • Pensoft Publishers

      2021-10-06T21:10:48Z https: ... AV Alekseev author 2006a text RIAR Proceedings 2006a 1 23 32 10.1007/s10512-006-0185-2 P Askeljung author 2012 2012 AA Goncharov author 2016 2016 Integral In-Pile Experiments with VVER-440 and VVER-1000 Multielement Fuel Test Rigs under the LOCA Conditions. Izvestiya vuzov. ... (53)80001-1 HS Fogler author 1999 ...


    • CFD Modeling of Algae Flash Pyrolysis in the Batch ...

      Abstract The algae biomass is one of the potential biomass resources for extracting lipid to produce fuel. The off grade or residuals of dehydrated algae particles can be used in pyrolysis reactions to produce fuel or useful chemicals. Due to higher ash contents of algae biomass, pyrolysis process needs an appropriate design of pyrolysis reactor. The heating rate of algae biomass is a key ...


    • Dehumidification and thermal regeneration characterization ...

      The salts were vacuum dried at 10 mb pressure and 30 °C for about 6 -hours in a vacuum oven (101L Memmert Vacuum Oven - VO 500). Feed emission scanning electron microscopy (FE-SEM), Supra 55VP, Zeiss, with Energy-dispersive X-ray spectroscopy (EDX) characterization was conducted on each compound to affirm their elemental compositions and ...


    • Krishnan Kumar - Publications

      Year Citation Score; 2021: Kumar R, Kumar KJ, Benegal V, Roopesh BN, Ravi GS.Effectiveness of an Integrated Intervention Program for Alcoholism: Electrophysiological Findings. Indian Journal of Psychological Medicine. 43: 223-233.PMID 34345098 DOI: 10.1177/0253717620927870 : 1


    • www.sciencegate.app

      https://www.sciencegate.app/document/10.1103/physrevd.103.025008 2021-03-01T00:26:32.6+00:00 yearly 0.8 https://www.sciencegate.app/document/10.1364/fio.2020.fw1e.5 ...


    • [XLSX File]图书馆

      https://info.5y1.org/doi-10-1515-ijcre-2021-0185_1_5c3695.html

      2D Materials IOP PUBLISHING LTD http://iopscience.iop.org/2053-1583/ 2053-1583 ENGLAND 3 Biotech SPRINGER HEIDELBERG http://www.springerlink.com/content/2190-572X/


    • Optimization and experimental design by response surface ...

      Glutaric acid is an attractive chemical compound which can be used for the manufacturing of polyesters, polyamides, and polyols. It can be produced by the synthesis (chemical method) and fermentation (biological method) process. Glutaric acid is presented with the lowest quantity in the fermentation broth and industrial waste streams. The separation methods of glutaric acid are difficult ...


    • Catalytic Conversion of Alcohols into Value-Added Products ...

      Catalytic upgradation of biomass-derived glycerol, furfuryl alcohol and sugar-derived alcohols like sorbitol, mannitol and xylitol results in a range of value-added products. The origin of such processes, process chemistry, development of catalysts, recent advances and future trends are covered in this chapter.


Nearby & related entries: