Domestic hot water tempering valve
[DOC File]SECTION 221119 - DOMESTIC WATER PIPING SPECIALTIES
https://info.5y1.org/domestic-hot-water-tempering-valve_1_a541ce.html
Copy "Primary Water Tempering Valves" Paragraph below and re-edit for each type of water tempering valve required. If only one type is required, drawing designation may be omitted. Primary water tempering valves in paragraph below are available in …
[DOCX File]ipf.msu.edu
https://info.5y1.org/domestic-hot-water-tempering-valve_1_bc788c.html
Connect hot- and cold-water-supply piping to hot- and cold-water, water-tempering equipment. Connect output from water-tempering equipment to emergency plumbing fixtures. Comply with requirements for hot- and cold-water piping specified in Division 22 Section "Domestic …
[DOC File]INSTALLATION INSTUCTIONS
https://info.5y1.org/domestic-hot-water-tempering-valve_1_f02848.html
A gate valve place near the pump will allow for manual control of the water flow. Shut off hot water heat and the cold water supply to it and drain completely. Remove the existing temp/pressure relief valve on the hot water heater and replace it with a ¾” short nipple and tee. Install a new valve and run an escape line downward (1) as shown.
[DOC File]SECTION 232500 - HVAC WATER TREATMENT
https://info.5y1.org/domestic-hot-water-tempering-valve_1_4cd0f2.html
Inlet Water Tempering Valve: Thermostatic water-tempering valve to maintain 77°F inlet water temperature to RO unit. Activated Carbon Filter: Media Tank: Fiberglass-reinforced polyester rated for minimum 150 psig with internal backwash distributor and filtered water collector.
[DOC File]Specifications for Solar Water Heating Systems
https://info.5y1.org/domestic-hot-water-tempering-valve_1_7e2bef.html
2.7.3 Tempering Valve (VERY IMPORTANT) All systems installed under this procurement action MUST have a tempering or mixing valve to limit the temperature of the hot water supplied to the plumbing fixtures. The tempering valve is to be located downstream of the electric water heater and is to be set to a temperature suitable for the application.
[DOCX File]Home | Holby Valve
https://info.5y1.org/domestic-hot-water-tempering-valve_1_36f947.html
May 01, 2016 · Install thermostatic mixing/tempering valves as indicated on drawings and per valve manufacturer’s recommendations. The general arrangement shall be such that the tempered hot water recirculation pump discharge piping shall tie into the cold water branch feeding the domestic hot water system.
[DOC File]SECTION 221119 - DOMESTIC WATER PIPING SPECIALTIES
https://info.5y1.org/domestic-hot-water-tempering-valve_1_109a26.html
Point-of-Use Water Tempering Valves: ASSE 1016, or 1070, with piston-control mechanism, positive shutoff of hot water when cold water supply is lost, bronze body and cap with replaceable corrosion-resistant components, including stainless steel piston and liner. Valve Body Finish: [Rough bronze] [Chrome-plated bronze]. Set Point: Adjustable.
[DOC File]SECTION 224500 - EMERGENCY PLUMBING FIXTURES
https://info.5y1.org/domestic-hot-water-tempering-valve_1_af356c.html
Connect hot- and cold-water-supply piping to hot- and cold-water, water-tempering equipment. Connect output from water-tempering equipment to emergency plumbing fixtures. Comply with requirements for hot- and cold-water piping specified in Section 221116 "Domestic Water Piping." Retain first paragraph below if steam mixing valve is used.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.