Ge 30 amp disconnect
[DOCX File]757 ILLUSTRATED PARTS CATALOGUE
https://info.5y1.org/ge-30-amp-disconnect_1_83ef02.html
NOTE: Some of these tasks are covered under separate individual AMP Task Cards per the references given below. Inspection of the Engine Forward & Aft Mounts AMP Tasks 54-500-00-01 (L/H) & 54-504-00-01 (R/H) satisfy this requirement
PART 1 GENERAL - GE Industrial
[A separate source (common control) Two-wire terminal points shall be provided. One leg shall be wired through normally open auxiliary contacts in each disconnect and a control power fuse rated 1 amp shall be provided. Starter units shall be provided with the following auxiliary devices: [auxiliary starter interlocks, _____ N/O, _____N/C].
[DOC File]Power Generation Controls
https://info.5y1.org/ge-30-amp-disconnect_1_89962c.html
[Bus summing analog amp meter, scaled from zero to the maximum primary current based on the CT ratio, 4.5” switchboard meter with 1% accuracy and separate switch] [Bus analog power factor meter, scaled from 0.5 (lag) to 1 .0 to 0.5 (lead), 4.5” switchboard meter with 1% accuracy] [Power Quality Meter, GE PQM or equivalent]
[DOC File]1 - Eaton
https://info.5y1.org/ge-30-amp-disconnect_1_30c5fe.html
All 30 kV For complete connector rating, see IEEE Std 386™-2006 standard. ... The high voltage bushing shall be a one-piece, 150 kV, 200-amp large interface load-break bushing (Re: Catalog Data CA800021EN). ... Watt-hour meter package – includes GE® kV2c Encompass™ Electronic Meter. Factory supplied wiring shall be internal to the ...
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.