Glass for bathroom wall
[DOC File]26937 Demonstrate knowledge of materials for use in ...
https://info.5y1.org/glass-for-bathroom-wall_1_e6950b.html
Demonstrate knowledge of bathroom wall and floor protection for use in bathroom design. Evidence requirements. 4.1 Types of bathroom wall and floor protection are identified and described in terms of their use for a bathroom design. Range includes but is not limited to – tiles, glass…
[DOC File]Changes Made:
https://info.5y1.org/glass-for-bathroom-wall_1_96e719.html
The new bathroom construction shall be in compliance with Americans with Disabilities Act (ADA) and Architectural Barriers Act (ABA). The contractor shall provide demolition work, gypsum wall and ceiling work, waterproofing work, tile work, painting work, plumbing work, and bathroom sanitary ware and accessory installation work as per the drawings.
[DOCX File]SECTION 09 30 13 - CERAMIC/PORCELAIN TILING
https://info.5y1.org/glass-for-bathroom-wall_1_f90711.html
Detail wall, floor, and base edge, joints with other materials, and expansion joint conditions for each system. Show locations of expansion joints on drawings. Separate waterproofing membranes are required under mortar bed in new work specified in Sections 07 12 00, BUILT-UP BITUMINOUS WATERPROOFING, Section 07 13 52, MODIFIED BITUMINOUS SHEET ...
[DOCX File]Code Compliance Review Form: NYS Building Code
https://info.5y1.org/glass-for-bathroom-wall_1_52d757.html
No. Topic. Code Section. Required/Allowed. Actual. Comment. 2020 NYS BUILDING CODE. COMPLIANCE REVIEW FORM. Code Compliance Review: Building Code of New York State - Rev. 03/23/2020Page 6
[DOC File]DIVISION - SCOPE OF WORK - City of New York
https://info.5y1.org/glass-for-bathroom-wall_1_518aeb.html
Provide and install 4-1/4" x 4-1/4" glazed wall tile at kitchen walls where shown on drawings, at bathroom walls, at tub surrounds, and for all other walls as shown on drawings. Provide and install 4-1/4" x 4-1/4" sanitary cove base and bullnose for all bathroom walls.
Part 2 - Final ET - DGS
Glazing used in doors and panels of bathtub enclosures shall be fully tempered, laminated safety glass or approved plastic. When glass is used, it shall be 1/8 inch (3.2 mm) thick minimum when fully tempered, or 1/4 inch (6.4 mm) thick minimum when laminated, and shall pass the test requirements of this part, Chapter 24 Glass and Glazing.
[DOCX File]SECTION 10 28 00 - TOILET, BATH, AND LAUNDRY …
https://info.5y1.org/glass-for-bathroom-wall_1_c5b242.html
ASTM C1048, Kind FT, Condition A, Type 1, Class 1 for glass and mirrors in Mental Health and Behavior Patient Care Units, and Security Examination Rooms. PRODUCTS - GENERAL Basis of Design: Section 09 06 00, SCHEDULE FOR FINISHES.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.