Inline water metering in gallons
[DOC File]TRIPP COUNTY WATER USER DISTRICT
https://info.5y1.org/inline-water-metering-in-gallons_1_030595.html
Feb 21, 2017 · The temporary water user may have to have on site storage available. C. If the request is acceptable, TU shall pay district for all costs of installation; operation; and, removal, by District’s personnel or its contracted installer; a meter rental fee of $100.00; and, all water through the meter at the rate of $10.00 per 1000 gallons.
[DOCX File]Home | Infrastructure Planning and Facilities
https://info.5y1.org/inline-water-metering-in-gallons_1_3e499a.html
Inline flow meters shall be installed with upstream and downstream shutoff valves at each end of the metering run. If the flow meter size is smaller than line size (if approved by Mechanical Engineer), the reducers must be on the meter sides of the shutoff valves such that the shutoff valves are line size.
[DOC File]SECTION 221113 - FACILITY WATER DISTRIBUTION PIPING
https://info.5y1.org/inline-water-metering-in-gallons_1_f53eac.html
Water Meters: Install [compound] [turbine]-type water meters, NPS 3 (DN 80) and larger, in meter vaults. Include shutoff valves on water meter inlets and outlets and valved bypass around meters. Support meters, valves, and piping on brick or concrete piers. Water Meters: Install detector-type water meters in meter vault in accordance with AWWA M6.
[DOCX File]Cold Water Meters/ - Neptune Technology Group
https://info.5y1.org/inline-water-metering-in-gallons_1_3cb095.html
There have been federal changes to the acceptable amount of lead in the drinking water system. Knowing that water meters have a life expectancy of approximately twenty (20) years, the Utility wishes to ensure that meters purchased meet the Safe Drinking Water Act (SDWA) per NSF/ANSI 372 for the following reasons:
[DOCX File]Model Water Efficient Landscape Ordinance
https://info.5y1.org/inline-water-metering-in-gallons_1_6d2b5d.html
The Maximum Applied Water Allowance is calculated based on the maximum ETAF allowed (0.55 for residential areas and 0.45 for non-residential areas) and expressed as annual gallons required. The Estimated Total Water Use (ETWU) is calculated based on the plants used and irrigation method selected for the landscape design. ETWU must be below the ...
[DOC File]Our letterhead - MARLO
https://info.5y1.org/inline-water-metering-in-gallons_1_dad2ad.html
As an alternative to water softening for membrane scaling prevention, an injection of a polymeric scale inhibitor shall be provided. The injection system shall consist of an electronic positive displacement metering pump with PVC wetted parts, 35-gallon polyethylene day solution tank, electric solution mixer, liquid level switch, and foot valve.
ULTRASONIC FLOW METER, TREATED CHILLED WATER WITH …
Onicon FT-3100 Inline Electromagnetic Flow Meter with remote display . Badger Industrial Turbine Meter MS-ER1 (Bronze head, EPR seals) Honeywell Elster AMCO H4400 Turbine Meter . Or equal, as approved by UEM Energy Engineer . 232200S05 BUILDING STEAM CONDENSATE METERING. 16430S11 - 2 REV JUN 94
[DOCX File]16 - Maine
https://info.5y1.org/inline-water-metering-in-gallons_1_ad570d.html
3-2.2All stored water sources shall have an automatic filling mechanism set to regulate the available water supply volume from a minimum low water level equal to 110% of the calculated volume to a minimum high water level of 125% of the calculated volume, or, an audible water level alarm set to give a steady signal when the water level falls ...
[DOC File]VOLUME I - SCE
https://info.5y1.org/inline-water-metering-in-gallons_1_42e0da.html
At the top of this list is California’s water-energy relationship: water-related energy use consumes 19 percent of the state’s electricity, 30 percent of its natural gas, and 88 billion gallons of diesel fuel every year – and this demand is growing. As water demand grows, so grows energy demand.
[DOC File]Trident Tech
https://info.5y1.org/inline-water-metering-in-gallons_1_b43dc6.html
5. Inline flow meter with operating range of 0 to ____ gallons per hour with 1/2 inch male NPT inlet and outlet connections. 6. Metering valve with 1/2” female NPT connections. Kynar material. 7. Check valve with 1/2” male NPT connection to metering valve and 3/8” hose connection for mixed oxidant suction -- integral to venturi injector. 8.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.