Isolators for air compressor feet
[DOCX File]15973b
https://info.5y1.org/isolators-for-air-compressor-feet_1_91c900.html
Install air compressor assembly on concrete foundation with sole plates and vibration isolators where indicated on drawings. See section 23 05 48 for vibration isolation requirements. Level, grout, and bolt in place. Pipe automatic condensate drain from air storage tank to nearest floor drain; use copper drain line.
[DOCX File]Section 23 34 00 - HVAC FANS - Veterans Affairs
https://info.5y1.org/isolators-for-air-compressor-feet_1_fe5c3f.html
I.Section 23 73 00, INDOOR CENTRAL-STATION AIR-HANDLING UNITS. //J. Section 23 82 16, AIR COILS.// K.Section 26 29 11, LOW-VOLTAGE MOTOR STARTERS. 1.3 QUALITY ASSURANCE . A.Refer to paragraph, QUALITY ASSURANCE, in Section 23 …
[DOC File]SECTION 237433 - DEDICATED OUTDOOR-AIR UNITS
https://info.5y1.org/isolators-for-air-compressor-feet_1_c7a1bb.html
The air duct smoke detector housing shall be UL listed per UL 268A specifically for use in air handling systems. The air duct smoke detector housing shall be suitable for mounting indoors. The detector shall operate at air velocities of 100 feet per minute to 4000 feet per minute.
[DOCX File]Architecture Engineering and Construction
https://info.5y1.org/isolators-for-air-compressor-feet_1_b513eb.html
_____ARCHITECTURE, ENGINEERING AND CONSTRUCTIONARCHITECTURE & ENGINEERING326 East Hoover, Mail Stop BAnn Arbor, MI 48109-1002Phone: 734-764-3414Fax: 734-936-3334
Data Aire Series DX Units Guide Specifcations
The compressor shall come on at setpoint plus deadband plus 1.3° (the valve shall be 100% open at this point). The compressor shall go off at setpoint plus 1.3°. The valve shall close proportionally - 10% for each 0.1° below setpoint. An air discharge sensor shall be factory mounted.
[DOC File]Data Aire Series DX Units Guide Specifcations
https://info.5y1.org/isolators-for-air-compressor-feet_1_52a143.html
25 feet of shielded cable shall be provided for field wiring. ... provided with semi-hermetic compressors. Compressor shall have suction gas cooled motor, thermal overloads, vibration isolators, oil sight-glass, reversible oil pump, suction and discharge ports, manual reset high pressure switch, with a maximum operating speed of 1750 rpm ...
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.