Lab dc power supply
[DOCX File]Lab 1 - Weber State University
https://info.5y1.org/lab-dc-power-supply_1_f6617f.html
Lab 2: DC Test Equipment. Purpose: This lab will introduce many of the fundamental test equipment and procedures used for. verifying the operations of electrical circuits. Equipment and Components: Multimeter. Power supply. Protoboard. Resistors: 4.7 kΩ, 10 kΩ, 1 MΩ. Procedure: Search for resistor color code online. Copy it in your lab book.
[DOC File]Notes on Lab #1 - dc Circuits
https://info.5y1.org/lab-dc-power-supply_1_ad3814.html
The dc power supplies inside your big black breadboards contain a voltage regulator.xc 3.6 Diode Limiter (Student Manual Lab 3-7) Some instruments can be damaged or destroyed if too large a voltage is applied to the input.
[DOCX File]Lab #2 Help Document
https://info.5y1.org/lab-dc-power-supply_1_78a0ac.html
To measure the DC current through a resistor, you will need the DMM and the DC Power supply. First, make sure that the DC power supply is correctly configured and set the voltage to the value indicated in the lab using the rightmost voltage knob.
[DOC File]ECE 221L * Electric Circuits I Lab
https://info.5y1.org/lab-dc-power-supply_1_be2a98.html
Lab 1 : Introduction to Basic Lab Equipment. Objective: To become familiar with building a circuit on a protoboard, using a DC power supply and making measurements with a multimeter. Equipment: Lab bench DC power supply, multimeter and computer. ECE toolbox with protoboard, wires, cables and assorted resistors. Introduction: Welcome to the ECE ...
[DOC File]EE 101 Lab 1 Batteries, Power Supplies, and Resistors
https://info.5y1.org/lab-dc-power-supply_1_5d6248.html
P5. → Set the DC Bench supply to produce 8 volts between the red and black terminals of the “A” supply. Use the DMM to monitor the voltage while you adjust the supply knob. Demonstrate for your instructor or lab TA that you can adjust the supply to any specified voltage between 2 volts and 15 volts. Instructor/TA initials 1-2. Rev. 9/4/2010
[DOC File]EE 452, Power Systems Laboratory, Lab #1
https://info.5y1.org/lab-dc-power-supply_1_17859c.html
Connect the AC input of the unregulated supply to the variable AC power supply as shown in Figure 3.1. Connect the heat lamp to the DC output of the supply. Figure 3.1. Unregulated DC power supply with resistive load. Apply 50 Vrms to the circuit and measure: RMS source current (Irms) RMS fundamental component of source current (I1,rms).
[DOC File]Notes on Lab #1 - dc Circuits
https://info.5y1.org/lab-dc-power-supply_1_e933fb.html
1.1.3 Voltage (Power) Supply. An ideal voltage (or power) supply is defined to be a device that maintains a constant voltage difference between its two terminals independent of the "load" that is connected to these terminals. For example: A battery is a type of dc voltage supply.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.