Metal fasteners paper
[DOC File]07620 – SHEET METAL FLASHING AND TRIM
https://info.5y1.org/metal-fasteners-paper_1_4d86bc.html
C. Slip Sheet: Rosin-sized paper, minimum 3 lb/100 sq. ft. D. Fasteners: Wood screws, annular threaded nails, self-tapping screws, self-locking rivets and bolts, and other suitable fasteners designed to withstand design loads. 1. Exposed Fasteners: Heads matching color of sheet metal by means of plastic caps or factory-applied coatings. 2.
[DOCX File]SECTION 07 60 00, FLASHING AND SHEET METAL
https://info.5y1.org/metal-fasteners-paper_1_b285b8.html
Copper Covered Paper: Fabricated of electro-deposit pure copper sheets ASTM B 370, bonded with special asphalt compound to both sides of creped, reinforced building paper, UU-B-790, Type I, style 5, or to a three ply sheet of asphalt impregnated crepe paper. Grooves running along the width of sheet.
[DOC File]Section 13 34 19 - Metal Building Systems
https://info.5y1.org/metal-fasteners-paper_1_6e055b.html
Fasteners: Metal-backed rubber washer to serve as torque indicator. Exposed fasteners penetrating metal roof membrane at the following locations do not exceed the frequency listed: Basic Panel System: 0 per square foot. High Eave Trim, No Parapet: 2 per linear foot. Exterior Eave Gutter: 2 per linear foot. Panel Splices: 2 per linear foot.
[DOC File]SECTION 074013 - ROOFING AND SIDING METAL PANELS
https://info.5y1.org/metal-fasteners-paper_1_4115a7.html
Apply building paper to metal framing prior to installing sub-girts. Lap 2 inches (50 mm) min. at edges and 6 inches (150 mm) at ends and fasten with self-tapping metal screws with neoprene washers. ... Where exposed fasteners are required for formed metal trim, they shall be uniformly spaced and aligned. Heads of exposed fasteners shall match ...
SECTION 076200 - SHEET METAL FLASHING AND TRIM
Paper Slip-Sheet: 5-lb (2.27 kg) rosin-sized building paper. ... 20-gauge bronze or nonmagnetic stainless steel mesh or fabricated units, with selvaged edges and noncorrosive fasteners. Use materials compatible with gutters and downspouts. ... Sheet metal surfaces which will be exposed in the finished work are specified to be treated and prime ...
[DOC File]Sectopm 07 62 00 - Sheet Metal Flashing and Trim
https://info.5y1.org/metal-fasteners-paper_1_c2441b.html
Aug 28, 2012 · Galvanized Steel: ASTM A653/A653M, with G90/Z275 zinc coating; minimum 0.02 inch thick base metal. ACCESSORIES. Fasteners: Galvanized steel, with soft neoprene washers. Slip Sheet: Rosin sized building paper. Solder and Flux Items: Remelted or reworked solder will not be permitted. Types as recommended by manufacturer of sheet metal to be soldered.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Hot searches
- new york labor laws for 2019
- policy template for word
- 1200 calorie diet chart
- a level chemistry syllabus
- bureau of health professions
- antibiotic eye drops for conjunctivitis
- current political science topics
- move about meaning
- vp strategy and corporate development
- lumbar spine degenerative arthritis treatment