Nema outlet types chart: free download. On-line document store on 5y1.org

[DOC File]Dell Rack Engineering RapidPower PDU Best Practices
https://info.5y1.org/nema-outlet-types-chart_1_2d253c.html
The 15-amp NEMA product provides 5 NEMA 5-15R outlets protected by a 15-amp thermal circuit breaker. The IEC version provides 8 IEC 60320 -C13 outlets (7 outlets on front, one outlet on rear) and is protected by a 10-amp thermal circuit breaker for the 10-amp version and a 15-amp thermal circuit breaker for the 15-amp version.
nema types chart

[DOCX File]Section 22 61 13.74 - DENTAL COMPRESSED-AIR PIPING
https://info.5y1.org/nema-outlet-types-chart_1_9a0db8.html
Pressure switches and sensors shall be UL listed and shall be NEMA Type 4 watertight housing field adjustable pressure settings. The switch shall be wired //normally open// //normally closed//, 6 mm (1/4 inch) FNPT connection and fitted with a quick connect to facilitate field service. Electrical rating 10 amperes at 120-volt AC.//
nema plug types chart

[DOCX File]1063 RFP Section 4_FINAL_11272013
https://info.5y1.org/nema-outlet-types-chart_1_00c0e1.html
Conduit shall be provided from the outlet box to the nearest accessible ceiling if the ceiling space is not accessible. Provide insulated bushings on the ends of all tele/data conduits. If copper and fiber share the same cable tray, a barrier shall be installed to separate cable types.
nema type rating chart

[DOCX File]SECTION 11 82 19, PACKAGED INCINERATORS
https://info.5y1.org/nema-outlet-types-chart_1_1b5c50.html
Panel Construction: Cabinettype enclosure, hinged access door full size of panel, key lock, equipment mounted on subbases. Locate indicating lights, alarms, manual switches, recorder (if furnished) on outside face of panel. NEMA 3 panel for outdoor installations; NEMA 12 for indoor installations (UL50).
nema 4 outlet

[DOCX File]15973b
https://info.5y1.org/nema-outlet-types-chart_1_91c900.html
List indicating types and grades of oil and/or grease, packing materials, normal and abnormal tolerances for devices, and method of equipment adjustment. Table noting full load power factor, service factor, NEMA design designation, insulation class and frame type for each motor provided. A complete set of record control drawings.
nema enclosure types chart

[DOCX File]Florida Building
https://info.5y1.org/nema-outlet-types-chart_1_1457cc.html
Underlayment types and installation for all roof coverings have been revised to be consistent with the recommendations from IBHS to create a “sealed roof deck.” The key changes are as follows: where felt underlayment is used, it must be 30# or equivalent (ASTM D 226 Type II, ASTM D4869 Types III or IV)
nema number chart

[DOC File]913 - Indiana
https://info.5y1.org/nema-outlet-types-chart_1_023a20.html
The convenience outlet shall be duplex, three-prong, NEMA Type 5-15R grounding outlet in accordance with NEMA WD-6, with ground-fault circuit interruption as defined by the National Electric Code. These units shall be protected with a 15-amp cartridge fuse wired ahead of the multi-breakers.
nema 20 outlet

[DOC File]TRAFFIC SIGNAL CONTROLLERS, CABINETS, AND STRUCTURES
https://info.5y1.org/nema-outlet-types-chart_1_a62f39.html
The convenience outlet shall be duplex, three-prong, NEMA Type 5-15R grounding outlet in accordance with NEMA WD-6, with ground-fault circuit interruption as defined by the National Electric Code. These units shall be protected with a 15 A cartridge fuse wired ahead of the multi breakers.
nema outlets chart

[DOC File]EGSA - Electrical Generating Systems Association
https://info.5y1.org/nema-outlet-types-chart_1_d68d73.html
The manufacturer of the generator set is responsible for the torsional and bending compatibility of rotating components per NEMA MG1-16.82 or NEMA MG1-22.82. 5.2 Ratings. Generators for use with most generating sets are rated in kW or kVA at an assumed minimum power factor of 0.8 lagging and at the specified output voltage and frequency.
nema types chart

[DOC File]DIVISION 25 SPECIFICATIONS AND GUIDELINES
https://info.5y1.org/nema-outlet-types-chart_1_0230bb.html
The following National Electrical Manufacturers Association (NEMA) Standards. NEMA, RN1, 1998 PVC Externally Coated Galvanized Rigid Steel Conduit and Intermediate Metal Conduit. NEMA, TC3, 1999 PVC fittings for use with Rigid PVC Conduit and tubing. NEMA. TC 6. 1999 PVC and ABS Plastic Utilities Duct for Underground Installation
nema plug types chart

Nema outlet types chart