Psi to feet of water

    • [DOC File]Since pump curves often are in head - feet or meters, its ...

      https://info.5y1.org/psi-to-feet-of-water_1_098209.html

      Since pressure gauges often are calibrated in pressure - psi or bar, it may be necessary with a conversion to head - feet or meter, common used in pump curves. Converting pressure in psi to head in feet. h = p 2.31 / SG (3) where. h = head (ft) p = pressure (psi) Converting pressure in bar to head in meter. h = p 10.197 / SG (4) where. h = head (m)

      ft head to psi


    • [DOC File]Conversion Sheet Page 1 - California State Water Resources ...

      https://info.5y1.org/psi-to-feet-of-water_1_974354.html

      PSI = ( Head, ft. ) PSI = Head, ft. x 0. 433 PSI/ft. 2.31ft./psi. lbs Force = (0.785) ( D, ft. )2 x 144 in2/ft2 x PSI. CHLORINATION. Dosage, mg/l = (Demand, mg/l) + (Residual, mg/l) (Gas) lbs = Vol, MG x ppm or mg/L x 8.34 lbs/gal. HTH Solid (lbs) = (Vol, MG) x (ppm or mg/L) x 8.34 lbs/gal ( % Strength / 100 )

      convert head to psi for water


    • [DOC File]2 HOUR HIGH PRESSURE LEAKAGE TEST, WATER MAIN …

      https://info.5y1.org/psi-to-feet-of-water_1_e1563e.html

      DATE: CONTRACT MANAGER: CONTRACT NO.: INSPECTOR: LOCATION: LINE & GRADE: CONTRACTOR: COMPUTED BY: SIZES & TYPES OF WATER MAIN: CHECKED BY: BOX 1 2 HOUR HIGH PRESSURE TEST High Hydraulic Gradient per contract drawings Minus lowest invert within test section – Total = X .434 Equals the pressure at low point = Lowest Surge Pressure per Standard Specifications + Total = PSI …

      psi to feet in head


    • [DOC File]California State University, Northridge

      https://info.5y1.org/psi-to-feet-of-water_1_bf8a60.html

      Pipes A and B both contain water. If the pressure in pipe A is decreased by 1.3 psi and the pressure in pipe B increases by 0.9 psi, determine the new differential reading of the manometer. There is a common pressure on both sides of the manometer at the point of the lower water-gage-fluid interface.

      convert psi to ft


    • [DOC File]OPERATION AND MAINTENANCE MANUAL

      https://info.5y1.org/psi-to-feet-of-water_1_7a55c6.html

      Raw water is supplied to the system by three (3) 300 GPM @ 65 PSI well pumps pumping from 6 inch casings 600 feet deep with 20 feet long 6 inch screens. The pumps are automatically started and stopped by level control on an elevated 150,000 gallons storage tank. The elevation of the tank maintains 42 to 50 PSI on the distribution system.

      foot of water to psi


Nearby & related entries:

To fulfill the demand for quickly locating and searching documents.

It is intelligent file search solution for home and business.

Literature Lottery

Advertisement