Show size of 8mm
[DOC File]SECTION 092216 - NON-STRUCTURAL METAL FRAMING
https://info.5y1.org/show-size-of-8mm_1_837443.html
Flange Size: 1-1/4 inches (32 mm). ... Members that can show certified third-party testing with gypsum board in accordance with ICC-ES AC86 (Reapproved August 2015) need not comply with minimum thickness limitation or minimum section properties set forth in ASTM C645. The submission of an evaluation report is acceptable to show compliance with ...
[DOC File]Wall Protection, Door Protection, Sustainable Building ...
https://info.5y1.org/show-size-of-8mm_1_457926.html
Position the vinyl retainer against the wall, allowing 5/16" (8mm) from the bottom of the retainer to the top of the cove base or baseboard for the bottom cap. Drywall: Secure the retainer to the wall using #8 x 1-1/4" Phillips round head, self-tapping screws. Stagger the fasteners on each wing of the retainer.
[DOC File]SECTION 02874 – BICYCLE PARKING RACKS
https://info.5y1.org/show-size-of-8mm_1_1fa3cf.html
Top shall be constructed of 2” (50.8mm) carbon steel angle; 3/8” (9.6mm) carbon steel flat plate. 1. IPE wood shall be 2” x 4” (50.8mm x 101.6mm) or 3” x 4” (76.2mm x 101.6mm) nominal unfinished solid stock with eased edges. 2.
[DOC File]Wall Protection, Door Protection, Sustainable Building ...
https://info.5y1.org/show-size-of-8mm_1_fdd753.html
1. Position the aluminum retainer against the wall, allowing 5/16" (8mm) from the bottom of the aluminum to the top of the cove base or baseboard for the bottom cap. 2. Aluminum Retainer Installation. Drywall installation: Secure the aluminum retainer to the wall using 1-1/4" Phillips round head self-tapping screws.
[DOCX File]PART 2 – PRODUCTS
https://info.5y1.org/show-size-of-8mm_1_960c34.html
Installed panels shall have horizontal and vertical joints of equal dimension. 8mm joints are the recommended joint width subject to design of panel module. Exact dimension of joint may vary depending on wall panel size. The joint allows for controlled expansion and contraction of panels.
[DOC File]Mariak
https://info.5y1.org/show-size-of-8mm_1_2bb8d8.html
S. Lift Cords: Lift cords shall be braided with polyester jacket and center core or approved equal. Size of cord shall be 1.8mm. Cords shall be detachable, if required, and shall be of sufficient length to properly control the raising or lowering of the blind. Lift cords shall be equipped with plastic tassels.
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.