Standard refrigeration parts: free download. On-line document store on 5y1.org

ARC
The equipment and accessories furnished by HEB include a manufacturer's standard one-year parts warranty. If any part or piece of equipment is found to be defective, it shall be the responsibility of the refrigeration Contractor/Subcontractor to secure a replacement from the manufacturer and install it without charge to H-E-B.
standard refrigeration llc

[DOCX File]Section 23 23 00 - Refrigeration Piping
https://info.5y1.org/standard-refrigeration-parts_1_7a5e08.html
Low side means the parts of a refrigeration system subjected to evaporator pressure. High side means the parts of a refrigeration system subjected to condenser pressure. Brazed joint: A gas-tight joint obtained by the joining of metal parts with alloys which melt at temperatures higher than 450 degrees C (842 degrees F) but less than the ...
standard refrigeration co

[DOC File]Section 23 23 00 - Refrigeration Piping
https://info.5y1.org/standard-refrigeration-parts_1_c51caa.html
B. Comply with ASHRAE Standard 15-2007, Safety Standard for Refrigeration Systems (ANSI Approved) and Standard 34-2007, Designation and Classification of Refrigerants. The application of this Code is intended to assure the safe design, construction, installation, operation, and inspection of every refrigeration system employing a fluid which ...
standard refrigeration receiver

[DOCX File]SECTION 11 41 21 - WALK-IN COOLERS AND FREEZERS
https://info.5y1.org/standard-refrigeration-parts_1_6f2e65.html
Included shall be a full one (1) year warranty for all parts by factory, full one (1) year compressor warranty by compressor manufacture and a 90-day warranty on labor on the entire refrigeration package only from the day of final acceptance of the installation as previously specified. Factory labor warranty does not cover installation.
standard condenser corporation

HVAC Guide Specifications
The units shall be rated in accordance with Air-conditioning Refrigeration Institute’s (ARI) Standard 240 and bear the ARI Certification label. The units shall be manufactured in a facility registered to ISO 9001 and ISO 14001, which is a set of standards applying to product and manufacturing quality and environmental management and ...
standard refrigeration catalog

[DOC File]STANDARD OPERATING PROCEDURE
https://info.5y1.org/standard-refrigeration-parts_1_e7e6c2.html
Clean plastic and non-metal parts with a fresh solution of 5% sodium hypochlorite (bleach) mixed 1:10 with water (one part bleach plus nine parts water). 4.7.4 Annual maintenance. The centrifuge must be serviced annually by a qualified service technician who must ensure that the unit operates safely and properly.
standard refrigeration water cooled condenser

[DOC File]STANDARD *SPECIFICATIONS FOR COOLERS & FREEZERS
https://info.5y1.org/standard-refrigeration-parts_1_622e64.html
STANDARD *SPECIFICATIONS. FOR COOLERS & FREEZERS. ... of one year and three months from the date of the original shipment and be limited to the repair and replacement of parts of the refrigeration equipment F.O.B. the factory which has been determined as defective upon the inspection disclosure by AIRCOOLER or by its authorized agent. ...
commercial refrigerator door parts

[DOC File]SECTION 237400 - PACKAGED OUTDOOR HVAC EQUIPMENT
https://info.5y1.org/standard-refrigeration-parts_1_8f345b.html
Unless otherwise noted, the referenced standard edition is the current one at the time of commencement of the Work. Refer to Division 01 Section "General Requirements" for the list of applicable regulatory requirements. Refer to Division 23 Section "Common Results for HVAC" for codes and standards, and other general requirements.
standard refrigeration company

Standard refrigeration parts