Trane condenser coil
How Do You Clean a Trane Condenser Coil
Condenser coil will be made of aluminum fins mechanically bonded to seamless copper tubing and shall include integral subcooling circuit. Coils will be factory leak tested at 3.2Mpa under water. If unit will be installed on corrosive environment, aluminum fins will be pre-coated with gold epoxy, with minimum thickness of 8µm, in order to ...
[DOC File]RTAD Heat Recovery Unit Description
https://info.5y1.org/trane-condenser-coil_1_28cc84.html
Condenser Coil: Non-ferrous construction consisting of aluminum plate fins mechanically bonded to seamless copper tubes and circuited for subcooling. Condenser coil shall have coil protection screens on to prevent coil damage. Condenser Fans and Motors: Direct-driven propeller type fans with permanently lubricated motors.
[DOC File]SECTION 238100 - DECENTRALIZED UNITARY HVAC …
https://info.5y1.org/trane-condenser-coil_1_c11bfa.html
Ensure that the cooling coil is 10-25 Ton VAV Packaged CS RTU Update static pressure to 3.5” wg Add economizer control based the requirements for ASHRAE 90.1 …
[DOC File]Guide specifications FCD-FED-FCU-FEU - Trane
https://info.5y1.org/trane-condenser-coil_1_a2d371.html
A coated wire mesh that covers the coil along the sides of the unit. Access Guards and Half Louvers. A coated wire mesh covers the access area under the condenser coils and half louvers cover the condenser coil. Architectural Louvered Panels. Louvered panels cover the complete condensing coil and service area beneath the condenser. Half Louvers
[DOC File]VOYG.DOC
https://info.5y1.org/trane-condenser-coil_1_9a5188.html
Condenser Coil: Seamless copper-tube, aluminum-fin coil, including subcooling circuit and backseating liquid-line service access valve. Factory pressure test coils, then dehydrate by drawing a vacuum and fill with a holding charge of nitrogen or refrigerant.
[DOCX File]Throughout the Day Exercise: Primary ...
https://info.5y1.org/trane-condenser-coil_1_eec83d.html
The DX coil must be intertwined; horizontal split coils are not acceptable. The vendor will be responsible for changing the coil out in the field if a horizontal coil is substituted with or without approved submittals. 2.08 CONDENSER SECTION. A. Provide all aluminum microchannel type coil…
Nearby & related entries:
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Hot searches
- rushmore financial
- financial management
- us department of education loan forgiveness
- education essay
- blackrock financial management
- argumentative essay topics
- title ix of the education amendments act of 1972
- more likely synonyms power thesaurus
- new york city department of education email
- marketing for small business