Water meter testing procedures

    • [DOCX File]NITP 14 National Instrument Test Procedures for Utility Meters

      https://info.5y1.org/water-meter-testing-procedures_1_7bbd02.html

      – The normal test of a meter shall be made at the maximum discharge rate developed by the installation. Meters with maximum gallon per minute ratings higher than the values specified in Table N.4.1. Flow Rate and Draft Size for Water Meters Normal Tests may be tested up to the meter rating, with meter indications no less than those shown.

      awwa water meter accuracy chart


    • [DOCX File]SOPs for Small Drinking water Systems

      https://info.5y1.org/water-meter-testing-procedures_1_4dc8f1.html

      Policies and Procedures. ... The testing reports shall be turned into SSWC within 30 days of receipt of the annual test notification. Tests and inspections may be required on a more frequent basis at the discretion of the certified cross connection specialist. ... Each meter will be read by the certified water manager (or designee) on or ...

      awwa water meter testing standards


    • How To: Meter Testing: How to Test Electronic Meters | WWD

      Water Works system. This manual contains the necessary O&M procedures, work sheets and record keeping forms, safety and emergency procedures, and testing and monitoring procedures. This manual is to be updated form time to time to reflect physical and procedural changes to the water system.

      water meter testing requirements


    • [DOC File]OPERATION AND MAINTENANCE MANUAL

      https://info.5y1.org/water-meter-testing-procedures_1_7a55c6.html

      However, in order for a water meter to be used for trade following in-service inspection, the meter must comply with the acceptance criteria specified below. Procedure The errors (of indication) of the water meters in the measurement of actual volume shall be determined at four flowrates across the flowrate range 0.075 Q 3 ≤ Q ≤ Q 4 .

      awwa water meter accuracy standards


    • Specifications, Tolerances, and Other Technical ...

      Water Testing Lab Water Testing Lab Chlorine Supplier Chemical Supplier ... transfer switch type, location, step by step procedures Exercise schedule and procedures Treatment - Other Chemical (e.g. corrosion control) Chemical name ... etc. Record water plant meter readings & calculate total daily production Average day demand in summer is ...

      water meter accuracy testing


    • [DOCX File]Water Submetering Application Form - Connecticut

      https://info.5y1.org/water-meter-testing-procedures_1_68757e.html

      Users will be notified. System will follow accepted procedures during repairs. 4. System flushing program: Each public water system should flush the water distribution system as necessary to reduce stagnant water and sediment build-up. Dead end lines will be flushed every three (3) months to remove sediment and reduce stagnant water.

      field testing water meters


    • [DOC File]Commissioning - M&E Prefunctional Checklists

      https://info.5y1.org/water-meter-testing-procedures_1_0294f9.html

      Describe the testing procedure that will be used to test the accuracy of the water meter pursuant to Sections 16-11-88 and 16-11-89 of the Regulations in . Exhibit C-6. b(1). If a “certified test bench” will not be utilized, provide as . Exhibit C-6. b(2)

      awwa meter test guidelines


    • [DOC File]Water System Procedures

      https://info.5y1.org/water-meter-testing-procedures_1_c46ae9.html

      Specific procedures for certain spaces or types of spaces must be developed and documented by the department or organization to ensure safe entries. Employees entering those spaces must be trained in the specific procedures. Procedures must also be developed for certain work tasks that will be performed in a confined space.

      awwa meter testing accuracy table


    • [DOC File]SOPs for Small Drinking water Systems

      https://info.5y1.org/water-meter-testing-procedures_1_1d615f.html

      SOPs for Small Drinking water Systems Description: This SOP version is intended for small, very simple drinking water systems. Keywords: SOP, drinking water, standard, operations, proceduses, Last modified by: tim@ohioruralwater.org Company: Collaboration between NYSDOH and NYRWA

      awwa water meter accuracy chart


    • [DOCX File]Scenic Shores Water Company (SSWC)

      https://info.5y1.org/water-meter-testing-procedures_1_df5200.html

      Water: pump curves, circuit setter, flow station, ultrasonic meter.) Specific procedures that will ensure (and which can be verified) that both air side and water side are operating at the lowest possible pressures and energy consumption.

      awwa water meter testing standards


Nearby & related entries: