3 phase fused disconnect switch: free download. On-line document store on 5y1.org

PART 1 GENERAL - GE Industrial
Each motor starter(s) shall be complete self-contained Class E-2 Combination Starters and house the fused disconnect switch, in-line isolation contactor, solid-state controller, motor overload protection and bypass contactor. ... Output: Reduced voltage 3 phase AC derived from phase-angle fired inverse-parallel thyristors, ramped to full voltage.
600 volt 3 phase disconnect

[DOCX File]SECTION 283111 - DIGITAL, ADDRESSABLE FIRE-ALARM …
https://info.5y1.org/3-phase-fused-disconnect-switch_1_c90376.html
Disconnect switch electrical interlock where indicated. Motor starters shall be a minimum NEMA Size 1. Fused disconnect switch units, circuit breaker units, and combination motor starter units shall have the disconnect and the door interlocked to prevent the unit door from being opened when the unit is on.
3 phase 30 amp disconnect

SECTION 262816.11 - SAFETY DISCONNECT SWITCHES
2, 3, 4 and 6 poles (2, 3 and 4 poles on 800 A; 2 and 3 poles on 1200 A). Fusible and non-fusible. Mechanical lugs suitable for copper conductors. Construction: Switch blades and jaws shall be visible and plated copper. Switches shall have a handle that is easily pad-lockable with three 3/8-inch shank locks in the OFF position.
3 phase 60 amp disconnect

[DOC File]PSG Section 26 28 16.13 - Eaton
https://info.5y1.org/3-phase-fused-disconnect-switch_1_b52be5.html
2, 3, 4 and 6 poles (2, 3 and 4 poles on 800 A; 2 and 3 poles on 1200 A) Fusible and non-fusible. Mechanical lugs suitable for aluminum or copper conductors. Construction. Switch blades and jaws shall be visible and plated copper. Switches shall have a red handle that is easily pad-lockable with three 3/8-inch shank locks in the OFF position
3 phase 400 amp disconnect

[DOCX File]SECTION 22 05 13
https://info.5y1.org/3-phase-fused-disconnect-switch_1_b53add.html
Provide 3 overload relays, one for each phase of the three phase starter. Provide fused disconnect switches for combination starters with Class R type fuse rejection clips. If breakers are shown, provide breakers with a minimum of 65,000 RMS symmetrical amps interrupting capacity.
square d 3 phase disconnect

[DOC File]SECTION 14200
https://info.5y1.org/3-phase-fused-disconnect-switch_1_698c40.html
2. Fused disconnect switch or enclosed circuit breaker with auxiliary contact. 3. Single phase circuit for elevator cab lighting, terminating in a fused disconnect switch or circuit breaker in elevator machine room. 4. Smoke detection system for Phase I - Emergency Recall Operation terminating at a terminal strip cabinet in elevator machine ...
safety disconnect switch 3 phase

[DOC File]END OF SECTION
https://info.5y1.org/3-phase-fused-disconnect-switch_1_784285.html
[3][4] - Fused disconnect switches, one for each pump and one for the control transformer. [2][3] - Run time meter, one for each vacuum pump. A cam time alternator to automatically switch lead/lag operating sequence of the pumps. A phase failure relay (Refer to Section 23 04 00). Primary and secondary fused control power transformer.
three phase disconnect

[DOCX File]ELECTRICAL FOR STEAM UTILITY DISTRIBUTION
https://info.5y1.org/3-phase-fused-disconnect-switch_1_5b1aca.html
Provide combination, full voltage, nonreversing magnetic starters and fusible disconnect switches in a common enclosure. Fractional sizes and ratings in accordance with IEC recommendations are not acceptable. Provide fused 3-pole load break disconnect switches with time delay, dual element fuses, external operating handle, and lock-off facility.
three phase disconnect switch

[DOCX File]END OF SECTION - University of Houston
https://info.5y1.org/3-phase-fused-disconnect-switch_1_89f5dc.html
Controller: The jockey pump controller shall contain a FVNR magnetic starter with 3-phase overload protection, fused disconnect, control power transformer, H-O-A selector switch and an adjustable mercury-in-tube pressure control all housed in a NEMA 1 enclosure with door mounted disconnect …
600 volt 3 phase disconnect

[DOCX File]Section 26 29 21, Enclosed Switches and Circuit Breakers
https://info.5y1.org/3-phase-fused-disconnect-switch_1_5ab58d.html
3.3 spare parts A.Two weeks prior to the final inspection, furnish one complete set of spare fuses for each fused disconnect switch installed on the project. Deliver the …
3 phase 30 amp disconnect

3 phase fused disconnect switch